Page 1 of 1

The position of holding the racket handle and modded anims

PostPosted: 17 Mar 2012, 19:33
by NOLE.LUCKY
Hi manutoo
I added a few anims, actually replaced some old ones and was glad they were able to work online. But, I notcied that the player holds the racket handle a the middle, as compared to real players now who hold it toward the bottom (if not at the edge), such that the lower part of the racket isn't visible. Please have a look at that.

Secondly, for the two-handed backhand, please space the two hands, they are both stuck to each other at one position, it seems :D

Third, I also replaced a serve along with its servicewaiting anim, and found that I cannot use the serve online (infinte desynchs when the servewaiting motion starts). So, if I replace only the serveanim and leave the servicewaiting as it is, will I be able to use the modded serve online?

Thank you :jap:

Re: The position of holding the racket handle and modded ani

PostPosted: 18 Mar 2012, 05:01
by manutoo
=> topic8-6197.php

for Modded anim problem, ask the Modders...

Re: The position of holding the racket handle and modded ani

PostPosted: 18 Mar 2012, 06:13
by NOLE.LUCKY
Perhaps you didn't read the post entirely/properly :roll:

There is no PROBLEM as such, I was just asking you to make the player (in general, modded anim or intrinsic anim) hold the racket at the BOTTOM EDGE INSTEAD OF AT THE MIDDLE OF THE RACKET HANDLE AND SPACE OUT THE TWO HANDS OF THE PLAYER ON THE RACKET HANDLE A BIT WHEN HITTING A DOUBLE-HANDED SHOT.

Re: The position of holding the racket handle and modded ani

PostPosted: 19 Mar 2012, 05:07
by manutoo
Then in this case, I don't know what you're talking about, coz the player takes the handle by the end (it may have 1 or 2cm left, at max) ; and the hands on 2H-BH are normally positioned = joint but not overlapping.